esc
Type to search, or take a leap:
1959 AD·Computing·verified

Integrated Circuit

An entire circuit — transistors, resistors, wiring — manufactured as one piece on a single sliver of silicon.

Глубинный архив пока написан по-английски — выверенные переводы входят в план развития. Встроенный переводчик браузера хорошо справляется с этой страницей.

Integrated Circuit
Zephyris · CC BY-SA 3.0 · Wikimedia Commons

✦ Постойте, правда?

The insight was accepting worse parts: a silicon resistor is inferior to a real one, but if everything is silicon, the whole circuit can be printed at once — and printing scales in a way hand-wiring never can.

Что это

An entire electronic circuit — transistors, resistors, capacitors, and the wiring between them — fabricated together on a single small slice of semiconductor, instead of assembled from separately made parts soldered onto a board. The counterintuitive move was to build every component from the same material even where that material was a poor choice: silicon makes a mediocre resistor and a worse capacitor, but if the whole circuit is one piece of silicon, it can be manufactured in one process rather than wired together by hand.

Почему это было важно

By the late 1950s the most ambitious electronics were choking on their own connections — the "tyranny of numbers," in which a circuit of tens of thousands of parts needed tens of thousands of hand-soldered joints, any one of which could fail. The integrated circuit dissolved that ceiling: circuits stopped being assembled and started being printed, and the cost per transistor began the fall it has never stopped. That single economic fact — components getting cheaper the more of them you crowd onto a wafer — is the ground truth beneath every digital device since.

Как это делали

Two independent inventions, months apart, that the industry later fused. In September 1958 Jack Kilby at Texas Instruments etched a transistor, capacitor, and resistors into one sliver of germanium and joined them with fine gold "flying wires," making a working oscillator that proved a single crystal could hold an entire circuit. In 1959 Robert Noyce at Fairchild, building on Jean Hoerni's planar process, went further and made the connections part of the chip: components diffused into flat silicon and linked by aluminum lines laid over an insulating oxide layer — an interconnect that could be photolithographically printed, and therefore mass-produced. Kilby proved the concept; Noyce's planar silicon version made it manufacturable.

Что это открыло

The microprocessor and the memory chip, and through them essentially all computing after 1960. Because the same photolithographic step that defines one transistor defines a million at once, the integrated circuit turned Moore's Law from an observation into an industry — half a century of packing exponentially more onto each wafer. Every phone, satellite, and data center is a direct descendant of these first hand-wired slivers.

Минимальная работающая версия

Kilby's 1958 germanium sliver with one transistor, one capacitor, and resistors, hand-wired with gold; Noyce's planar silicon version (1959) made the printing scalable.

Нити, проходящие через эту способность

How did lightning become ChatGPT?12 шаговHow does sand become a CPU?7 шагов

Источники

  • T. R. Reid, *The Chip: How Two Americans Invented the Microchip and Launched a Revolution* (2001)
  • Computer History Museum, "The Silicon Engine": '1958 — All Semiconductor Solid Circuit is Demonstrated' and '1959 — Practical Monolithic Integrated Circuit Concept Patented'

Что-то не так на этой странице? Каждое утверждение здесь должно выдерживать проверку. Предложить исправление →